Looking for a recommendation from users who personally tested some laser rangefinders (laser-tape). (So do not want recommendations based on the device specifications - (marketing blabla))


  • mostly for indoor use (so, max. range not need be more as 40m)
  • wanted accuracy (and precision too) max. +- 2mm (would be better even less, 1.5mm or 1mm)
  • must have this accuracy at LOW DISTANCE (let say above 50cm)

The low distance accuracy is the crucial point, because all tests what I saw says, that the laser rangefinder is accurate only at distances above 2 meters or like. At lower distances usually the measuring error is even 5 - 10 mm or more. So, let say if I want measure the inner width of my doorway (78.4cm) want get accurate result (max.) +- 2mm.

Would be nice to also have

  • trigonometric calculations
  • continuous measuring mode
  • low-cost (Chinese OK)

but the low-range accuracy is the really needed feature.

1 Answer 1


I have a Bosch DLR165, which appears to have been produced around 2010. It's possible that I purchased mine that far back, or from eBay in later years. I found only one in today's eBay listing, but based on my experience with this one, I'd purchase a newer Bosch product with confidence.

The manual lists the maximum range at 50 meters, within your requirements. The manual also states a minimum of 50 millimeters. This I checked moments ago. I cannot attest to the precision/accuracy, but can confirm that when placed on a metric ruler, it reads 50 mm. I used an uncalibrated eyeball to place the tool and the opposite surface, but suggest that it would be within the specified 1.5 mm capability.

When moved one mm closer, an error message appeared.

For a different type of test, I measured the span of my door frame. The top and bottom measured 2 mm narrower than the center of the vertical section of the door. When I placed the aforementioned ruler under the tool (1.9 mm thick), the measurement was reduced by 2 mm, indicating that my door frame is warped and that the tool recognized the distance change. Repeated measurements resulted in consistent results.

This specific unit meets the "nice to have" list as well. As noted in the manual, there is a trigonometric mode that requires one to measure the two legs of a right triangle and the device will calculate the hypotenuse. I have not tested this feature, but have confidence that it will work as described.

I have used the continuous measuring mode as well. It is unremarkable in operation and works fine.

Bosch has a reputation (in my alleged mind) of creating quality products. It's certainly possible that this device and others from the same company would be made in China, but in such cases, oversight results in expected quality. A not-necessarily-marketing blah-blah review can be found at The Gadgeteer from which the image below has been presented.

bosch dlr165

The photo shows "Assembled in Malaysia" invalidating my China reference, but that was 8 years ago.

  • have the same model, can confirm the accuracy and precision
    – loonquawl
    Commented Nov 23, 2018 at 13:24

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.